Member of the Month

KilaTsunami
October, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

LOOKEE HEER!!

profile picture
Inbred_Redneck
Posts: 2776 - Karma: 28

Ok now that i have everyones attention, the BAJ forum is dead at the moment, and i was unsure of where to put this.  But i have this stainless steel pipe i have at home that used to be covered in insulation.  I want to try and make it into a rail but theres this impenetrable rubbery type caulk around like the end and the middle which probably held the insulation in place.  Ive tried Goo-gone and scraping it off with my knife, but both dont really work......so does anyone know of any hardcore shit that will take this stuff off, or at least soften it up?
Jan 6 2008 8:52AM
0 0
profile picture
Shorton
Posts: 2889 - Karma: 13
burn it, then scrape it, just grab a blowtorch
Jan 6 2008 10:00AM
0 0
profile picture
PatVigorito
Posts: 405 - Karma: 12
try that but if its not really sticky build it and start hitting it, itll probably work in
Jan 6 2008 12:15PM
0 0
All times are Eastern (-5)