Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Ski binding mounting fuck up
Posts: 686
-
Karma: 41
so i accidentally started to screw in my marker bindings without the air pad/riser thing and heard a small cracking noise, looked under the base then realised my mistake. i didnt go straight through, and didnt screw the bindings totally in, but there is a little buldge in my base, is this serious? are my skis finished?
Posts: 2146
-
Karma: 88
im not sure about this, but i think that's an unfixable mistake... a ski shop did that to my sisters skis a while back and had to replace them obviously, that's too bad tho dude.
Posts: 8227
-
Karma: 1,030
thats bunk the shop replaced with whole new skis^^
if its just a little bump then hit it with a hammer till it goes back or press it and compress with some clamps till it goes normal. If it didnt go through it should be that big of a problem.
Posts: 16030
-
Karma: 150
yeah hit them with a hammer
Posts: 6974
-
Karma: 79
Don't hit them with a hammer, that's just going to damage your base. You should be fine, just throw in the bindings. It's not like you can do anything about it now.
Posts: 4531
-
Karma: -7
use screwclamps. It will flatten in out.
All times are Eastern (-5)
