Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
How close is too clase for remounting bindings?
Posts: 1911
-
Karma: 156
how close to the origonal drill holes can you remount the bindings without compromising the strength of the ski?
Posts: 441
-
Karma: 12
definitly plug th holes and dont do within 2 or so hole widths id say. it wouldnt be to bad...
Posts: 2440
-
Karma: 62
Yea, definately use plugs. And i'm not sure if you need to go 2 plug widths (about 1/2cm) away, I've remounted skis that were only about 1 plug width away.
Posts: 4614
-
Karma: 101
1 plug hole is fine. if you are really worried, throw a heli coil in the there.
Posts: 1597
-
Karma: 17
dont use plugs. use epoxy. It will seal the whole much better and will never fall out.
And for the new holes, as long as it is more than 1/2 cm away it will be fine.
Posts: 13839
-
Karma: 7,704
Epoxy works pretty well, as for the distance away I can't say, 1 or 2 widths looks pretty solid though.
Posts: 753
-
Karma: 26
i was told by my local ski tech that 2 cm and make sre to plugem strong
All times are Eastern (-5)