Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
HOW DO I GET MY BINDINGS OFF MY SCRATCHES?
Posts: 1677
-
Karma: 26
cant get the screws undone
Posts: 398
-
Karma: 8
u have to go to a shop to do it, i highly doubt u have the right drill bit to take them off
Posts: 14332
-
Karma: 1,268
its not like its any special drill bit...
Posts: 1677
-
Karma: 26
But I do have 2 take them to the shop??
Posts: 12973
-
Karma: 500
Righty Tighty, Lefty Loosey. Using a screwdriver is pretty basic.
Posts: 1677
-
Karma: 26
^ but they seem too tight
Posts: 1250
-
Karma: 38
it actually is a special bit. it's not a phillips , its a posi.
Posts: 1677
-
Karma: 26
Which is? I gotta lotta tools, into motocross
Posts: 5536
-
Karma: -1
Posi-drive bit, it's basically the same as a phillips head, grab a #3 (I think) Posi bit or phillips bit and a drill, set the drill to high torque with a low speed, that should do it, just make sure you don't strip it out, then it's a real bitch.
Posts: 1250
-
Karma: 38
yeah #3 is posi. it's basically a phillips , but it has 4 extra mini teeth/blade things that grab the posi screws used in binding better. and if you have an adjustable torque , go to drill and slow speed, obviously breaking the tightness with a handheld posi driver would be ideal
Posts: 5639
-
Karma: 40
just get a bigger phillips head (or possi which ever) and pushing down helps to set the screwdriver in a lil better to
Posts: 934
-
Karma: 37
a big phillips works fine, more muscle, lefty loosey
Posts: 341
-
Karma: 10
Little tip though... use it manually to take them off. If the screws are jammed and you have the wrong torque setting chances are you will strip the screw. Press down hard and twist. If you see you're starting to strip bring them to a shop before the heads are totalled.
Posts: 2804
-
Karma: -5
cut up the skis around the screws.
Posts: 1484
-
Karma: 14
get stronger.
its not that hard.
All times are Eastern (-5)
