Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
How should i make a metal rail?
Posts: 1642
-
Karma: 103
should i countersink metal into a 2x4 like pvc rails? how should i make a metal rail if i have a bunch of steel pipes
Posts: 7404
-
Karma: 39
find somebody to weld them
Posts: 1642
-
Karma: 103
so like weld metal supports and everything? how much would that cost?
Posts: 4005
-
Karma: 38
I doubt welding would be very cheap. If you have steel pipes or tube, bolt the ends down from the bottom, so nothing sticks out of the top at all. If its a longer rail you can drill some holes and add some screws or lag bolts in the same way, just drill a pilot hole through the metal thats just big eneough to allow the scew to make it through while still having some holding power. I'd recomend building the rail without the metal and adding that last though, otherwise getting supports on wont be easy.
Posts: 4359
-
Karma: 1,382
What i do is make supports out of wood and attach pvc that i ripped in half. The rail then just sits in the pvc. I use a zip tie in the begging so the pipe doesent slide down the pvc, but you dont even really need this. It sounds sketchy but it actully works good.
Posts: 1595
-
Karma: 136
that does sound really sketch but i can see how it would work.
All times are Eastern (-5)
