Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Before I Toss out those shitty bindings, any suggestions for good new ones?
Posts: 5
-
Karma: 10
I have old, beat up bindings and need to get new ones. What sort of binding should i be looking at if I want to be jibbing and also shredding gnar. I have been setting my din around 10 on my early 2000s Solomon S810s.
thanks for the help
Posts: 21048
-
Karma: 5,061
well that's stupid, because the salomon 810 only goes up to a 10 din. cranking your dins to the max is not good for the springs inside the bindings and probably fucked em up pretty good. you should always have your din set to the middle of it's range, so if you usually set your dins to 10, buy a 6-14 binding.
Posts: 21048
-
Karma: 5,061
i.e, the salomon s914's or look px14's
Posts: 2829
-
Karma: 44
unless youre a big bastard like me, then go for the s916
Posts: 31125
-
Karma: 336
For safety reasons, don't bindings have to be designed to realease the same at every DIN setting?
Posts: 13785
-
Karma: 1,956
probably, btu that doesnt mean that there isnt more stress on all of the internal parts when you crank up the din.
Posts: 5
-
Karma: 10
i though it was the springs cuz i'm a light weight. Thanks for the imput
Posts: 53
-
Karma: 10
Posts: 534
-
Karma: 10
Ideally your DIN should be in the middle of your binding's range. Yes, they're designed to work properly at all the DIN settings, but having the springs away from either extremes will help it stay alive longer.
Also, the materials on a binding should be designed for the DIN range on it. So generally speaking, a binding with a DIN range of 6-14 should be a lot more durable than a binding with a DIN range of 2-9
All times are Eastern (-5)
