Member of the Month

KilaTsunami
October, 2024

Online

Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post. Register to become a member today!

Nasty ass topsheet shot

profile picture
Switchstyle
Posts: 1194 - Karma: 11
When I got done skiing last week i looked at my skis and a fucking triangle was "cut" out of the side of my topsheet on my pe's so now I have a regular top sheet except for a fucking triangle of which is about a square inch of area that has silver...fiberglass or threading i think; now for my question, is that bad?
Jan 11 2006 7:32PM
0 0
profile picture
AKoblitz
Posts: 1201 - Karma: 113
you should be fine if i understand correclty what your talking about above. I don't get those on my scratchs because of the side cut, but my friends get'em on their skis, and its ok as long as it doesn't go like down to the edge...
Jan 11 2006 7:37PM
0 0
profile picture
SSBS
Posts: 785 - Karma: 10
exactly... as long as the core or the edge arent affected, you should be good to go man
Jan 11 2006 7:38PM
0 0
profile picture
iridefattwins
Posts: 1126 - Karma: 16
ya that happend to me i just seled it up just in case
Jan 11 2006 7:40PM
0 0
profile picture
Switchstyle
Posts: 1194 - Karma: 11
what you use to seal? just in case sounds pretty good to me...
Jan 11 2006 7:41PM
0 0
profile picture
Tony_G
Posts: 431 - Karma: 12
dude maybe u should throw in some p-tex into just in case
Jan 11 2006 7:42PM
0 0
profile picture
Billek
Posts: 5665 - Karma: 98
Ptex or epoxy should do it....or some duct tape.
Jan 11 2006 7:54PM
0 0
profile picture
bmxican_89
Posts: 2617 - Karma: 23
use epoxy. not ptex. what year pes are they?
Jan 11 2006 7:56PM
0 0
profile picture
Switchstyle
Posts: 1194 - Karma: 11
06
Jan 11 2006 8:05PM
0 0
profile picture
rossiscratch04
Posts: 680 - Karma: 10
that sucks
Jan 11 2006 8:07PM
0 0
profile picture
bmxican_89
Posts: 2617 - Karma: 23
is it cut out like right around the edge of one of the colors? every colory is a separate piece so they fall apart. just trim off any edges where its peealing up and if you can see the core, fill it in with epoxy.
Jan 11 2006 8:12PM
0 0
profile picture
switched
Posts: 417 - Karma: 10
I think duct tape will work just fine. Just use the waterproof kind because I think snow is wet.
Jan 11 2006 8:19PM
0 0
All times are Eastern (-5)