Binding not flush with ski

I just bought new 04/05 1080's and had the shop mount Rossi Scratch 200 bindings at core centre. Haven't skiid the setup yet.

The other day I was checking out the mounting job and realised that on the rear left screw of one of the toe binding, the binding isnt flush with the ski....maybe like 1-2mm off.

My question is this...can I just crank it in with a screw driver? Or will it fuck up the glue (i.e. break the seal). It also might bend the binding.

I expect that if I take it back to the shop it's exactly what they'll do.

How serious is it anyway? should I stop worrying and just ride em?

Thanks for the input