Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
I need instructions on HOW to bend p10 brakes.
Posts: 7863
-
Karma: 22
I need exact instruction, because my dads just about to blow up my brakes while trying to bend them.
Posts: 11349
-
Karma: 2,333
umm you pretty much just pull them away from the ski if you want to you can heat them up with some heat gun or something like that
Posts: 7863
-
Karma: 22
If I bend both sides outward, will that mess up the plastic housing or something?
Posts: 2214
-
Karma: 259
Break a old pole and use the hollow hole of the pole to bend the brake out.
Posts: 4462
-
Karma: 298
Small soldering torch, heat the area you want the bend to be, then with plyers bend the metal. WATCH OUT IT IS HOT. this is best done in a vice.
Posts: 1304
-
Karma: 335
just... bend them. brakes are cheap anyways.
Posts: 1304
-
Karma: 335
just... bend them. brakes are cheap anyways.
Posts: 7863
-
Karma: 22
Posts: 3301
-
Karma: 13
use a blow dryer and heat them, then grab them with like a rag and bend them strait, then bend them back at the width u want
All times are Eastern (-5)
