Welcome to the Newschoolers forums! You may read the forums as a guest, however you must be a registered member to post.
Register to become a member today!
Adjusting Din on Look Heel piece
Posts: 1508
-
Karma: 12
HOw do you do it. It looks like you would do it in the screw on top of the piece but I cant get that screw to turn at all.
Posts: 1053
-
Karma: 103
yeah, and you gotta use a big screwdriver as well
Posts: 1508
-
Karma: 12
YEah its weird I had it up but the bolt seems locked. I used a big screwdrive as well. Ill go try again though.
Posts: 2171
-
Karma: 17
It is really hard to turn, I was adjustin the din on mine last season and it takes a while, the higher you go the harder it is.
Posts: 2628
-
Karma: 25
use a screwdriver with a long shaft to get down in there, it also makes it a little easier to turn.
Posts: 946
-
Karma: 16
Yeah its really hard, I just did it on my p12's about a half hour ago, the heel peice needs to be up and then turn that bastard like your giving a fat kid a snake bite, do it up.
Posts: 454
-
Karma: 10
Use a cordless drill with a posi-drive bit.
Posts: 946
-
Karma: 16
NO NO NO
Do not use a fucking drill, too much risk involved
Posts: 2783
-
Karma: 141
Posts: 2171
-
Karma: 17
Do it up just like he said.
Posts: 1343
-
Karma: 11
what does it matter if you use a electric drill, i use it all the time just take it slow
Posts: 946
-
Karma: 16
because the fuckin drill cant feel when its getting tough to turn the screw, and then it screws up the internals, you can feel when it gets tight, dont be a lazy dumb ass and ruin your stuff, just do it by hand
Posts: 1343
-
Karma: 11
what do you mean, just follow the numbers?
Posts: 946
-
Karma: 16
well you can use your drill, but I would RECOMMEND using a screwdriver
All times are Eastern (-5)
