Replying to Easy to make snowgun that actually works!

yeah so i was just meesin around and trying to make a snowgun and i did.
Materials:
1 piece of pvc pipie about two inches or less in diameter. it can be anywhwere from 6inches to 1foot long.
1 female end for air compressor.
1 female end for hose.
role of high grade tape( super addhiesive)
Directions first cut pipe to lenth
2nd- snad the edges of the pipe( make sure no pieces of plastic are left in side
drill two 1/2 inch hole about two inches apart.
Fit the female end for the air compressor in one and the female end for the hose in the other.seal about the drilled holes.
4th- drill about 20 tiny holes in a circular pattern directly in front of the fittings.
5th- tape each end of the pipe with about five layers of tape for each sidein a pattern like# cris cross.
seal around the pipie with one last twist.
finally test it. U must have a compressor that can keep above 100 psi for a long period of time. turn the water on just a litlle not to much.
it does work as long as its cold enough.try it ppl